WIRE FOR FLOOR ACCESS
The X1 Series Elevator Module provides 10 Form C (SPDT) 1 Amp relays for controlling
access to 10 floors. The three relay terminals are labeled for normally open (NO) and
normally closed (NC) operation. The center terminal is the common. See figures. These
allow you to connect the device wiring to the
relay for floor access control.
Warning:
Before wiring for floor
access, check with elevator service
company for their desired relay
operation for controlling the floors.
1.
Wire the number of controlled floors
to the elevator module. To wire
for floor access control, use the 10
terminals on the elevator module and
label them carefully for the elevator
service company.
2.
Allow extra wire so that the elevator
service company has enough length
to attach to the elevator control
center.
3.
Ensure the wires are in a logical
location for the elevator service
technician to find.
X1 ELEVATOR CONTROLLER QUICK START GUIDE | DIGITAL MONITORING PRODUCTS
2
Onboard Outputs
Use these terminals for local outputs or elevator alarms such
as sounders, lights, or sirens. These are 12 VDC outputs.
Aux Output 1 & 2 (O1 & O2)
Attach the negative wire of the device here.
12V+ (12V)
Attach the positive wire of the device here.
+AC/DC-
+BAT-
R1 W1 G1
B1
LC BC
R2 W2 G2 B2 LC BC
DS RX CI
G
01
02 12V
NC
C
NO
01 02 12V
X1 Elevator Controller
WIRE OPTIONAL INPUTS AND OUTPUTS
Onboard Inputs
Door Switch (DS) - Normally Closed
This terminal is not typically used for elevator access.
Connect a door contact or door position switch to indicate
status of the elevator, whether it is open or closed.
Request to Exit (RX) - Normally Open
This terminal is not typically used for elevator access.
Connect a motion sensing device or a mechanical switch to
provide RX capability to the controller.
Custom Input (CI) - Normally Open
This input triggers a custom action.
Ground (G)
This terminal is the ground for the inputs.
+AC/DC-
+BAT-
R1 W1 G1
B1
LC BC
R2 W2 G2 B2 LC BC
DS RX CI
G
01
02 12V
NC
C
NO
DS RX CI
G
X1 Elevator Controller
NC 1 NO
Normally Open
Common
Normally Closed
PWR
DATA
0 1
2
3
4
5
6
7
8
9
ADDR
6
1
7
8
9
10
2
3
4
5
NC 1 NO
NC 2 NO
NC 3 NO
NC 4 NO
NC 5 NO
NC 6 NO
NC 7 NO
NC 8 NO
NC 9 NO NC 10 NO
NC 1 NO
NC 1 NO
Normally Open
Normally Closed
Top 4-Wire Connector
to X1 Elevator Controller
X1 Elevator Module