20
Replacement Parts
Here.is.a.list.of.current.replaceable.parts.on.the.DK14S.as.of.the.writing.
of.this.manual:
MEN-DCCLP ...................DC16 (DK14S) CLAMP LINK ASSEMBLY
DKA-CTRLC ...................DIGITAL KNIGHT PROCESSOR BOARD
DKA-CTRLP ...................DIGITAL KNIGHT POWER BOARD
ELN-KM0227A1 .............DIGITAL KNIGHT MEMBRANE KEYPAD
RPK-DKPWR ..................DK POWER INLET/SWITCH/CORD KIT
ELN-VS10N031C ............TIMER LEVER MICRO SWITCH
DK14-HBA120 ................DK14S 12X14 HEATER BLOCK ASBLY 120V
SRM-381214 ....................3/8 X 12 X 14 SILICON SPONGE
DK14-SVLARM ..............DK14S SILVER POST & WHITE ARM ASBLY
DK14-STLBASE .............DK14S COMPLETE STEEL BASE
SHN-DK14HBC ..............DK14S 12 X 14 HBA COVER
SHN-DK14GD .................DK14S BENT REAR HBA GUIDE
DCA-LRGPBSFT ............DC LARGE PRESSURE BLOCK & SHAFT ASBLY
ELN-K26TC ....................K-26” THERMOCOUPLE
ELN-MSTB2.5.................OST 5MM TRMNL THERMOCOUPLE PLUG
The.majority.of.the.press.has.been.designed.to.be.as.maintenance.free.as.possible..
There.are.only.a.few.aspects.of.the.machine.that.should.be.monitored.to.insure.proper.
operation.
•
The clamp/linkage assembly is the greatest area of wear and friction on the press.
The posts that connect to the heat platen should be lubricated with SuperLube - a
clear high-temperature lubricant.
•
If the pins in the clamping mechanism wear, or the holes become elongated,
eventually the press will not lock properly. This can be very detrimental to pressing
results & quality! Contact the factory for very inexpensive clamp replacements to
get the clamps back to new condition.
•
The silicone pad on the lower table can degrade after much use and over an extended
period of time. This pad is replaceable. If the pad becomes dried out, cracked, or
there are chunks removed from the silicone pad, this can result in inconsistent and
poor quality transfers.
Maintenance / Misc
