2.5.1 Attach the Daughter Card and Install the Card Cage
Remove the daughter card from the XMI-1 card cage and
attach it to the XMI-2 card cage.
CAUTION:
The daughter card is static sensitive.
You must wear an
antistatic wrist strap attached to the cabinet when you handle this module.
1. Unpack the XMI-2 card cage (70-24902-02). Set it aside so that you can
mount the daughter card on it.
2. Three large thumbscrews hold the daughter card to the backplane (see
2
in Figure 2–11).
• Unscrew these three screws, working the daughter card out by
unscrewing each screw a little at a time.
• Pull the daughter card away from the backplane.
• Attach the daughter card to the XMI-2 card cage.
3. Bend back the power harnesses, and slide the XMI-2 card cage into the
cabinet. Push from the front and pull from the rear. This step requires
two people.
4. Use a nutdriver to tighten the four mounting nuts that secure the XMI-2
card cage to the front of the cabinet.
XMI-1 to XMI-2 Conversion
2–19
