1. Open the front cabinet door.
2. Remove the clear plastic door in front of the XMI-1 cage.
CAUTION:
You must wear an antistatic wrist strap attached to the
cabinet when you handle any modules. See Appendix A for processor
module handling instructions.
3. Lift up the levers and hold. Remove modules from the cage. Put them
in ESD boxes and note which slots they had been in.
4. Using a 1/4 inch nutdriver or a large flat screwdriver, remove and save
the four mounting screws (1/4 inch hex head) that fasten the XMI-1
cage assembly to the chassis. See
4
in Figure 2–5.
5. Pull the cage out of the system cabinet carefully so that you do not
damage the power harnesses or bus bars. Push from the back to ease
the cage out toward the front of the cabinet. This step requires two
people.
XMI-1 to XMI-2 Conversion
2–9