Installation
1.2 Monitor Installation
1.2 Monitor Installation
To connect your monitor:
1. Make sure the power to the monitor and the computer is off.
2. Connect the monitor’s signal cable to the 15-pin interface
connector on the High Resolution Graphic Video Adapter on the
back of the computer.
3. Plug in the ac power cord to the monitor, then to a
properly-grounded ac electrical outlet.
Turn On Power to Monitor
Push the power switch button
to turn on the monitor. The power
indicator LED to the right of this switch should light green.
Figure 1–1 PCXBV-Rx Monitor (Control Panel)
Contrast
– Turn this control to adjust the contrast.
Brightness
—Turn this control to adjust the brightness.
If the display is too small or not centered, the monitor does not
recognize the input frequency mode. Adjust the position and size of
the display using the controls in Table 1–1
1–2 Installation
