Digital Equipment DECserver 700-08, Hardware Owner'S Manual

Page: 52 / 77

5–4 Site Preparation and Maintenance
5.3 Installing Extra Memory
To install a SIM:
1. Disconnect all cables from the DECserver 700.
2. Remove the DECserver 700 brackets, if fitted (Figure 5–1).
3. Remove the DECserver 700 cover (Figure 5–2).
4. Fit the anti-static kit (Figure 5–3).
5. Locate the SIM connectors (Figure 5–4).
6. Remove the SIM from its wrappings and keep the memory label for step 10.
7. Insert the extra SIM in the connector (Figure 5–7).
8. Remove the anti-static kit.
9. Replace the cover (Figure 5–8).
10. Stick the memory label on the back of the DECserver 700.
11. Connect a terminal to the DECserver 700 (Section 7.5).
12. Reconnect the cables and test the DECserver 700 (refer to the DECserver 700
Hardware Installation Card).
NOTE
If the SIM memory is faulty, the DECserver 700 flashes
“C” if the faulty SIM is in connector 1 and “d” if the
faulty SIM is in connector 2. If you install the wrong
type SIM, the DECserver 700 flashes “n”. Remove or
replace the SIM to repair the DECserver 700.
13. Check status message 960 to verify memory size:
Local –960– Available memory 4 Mbytes