10
Explanation of the Starting Line Enhancer
The diagram below is to help understand how the Starting Line Enhancer works. When turned on, the Starting Line
Enhancer will close the throttle while the vehicle is being staged. This can be done two different ways, first, if a Tap Push-
button is pressed before a Transbrake Push-button is pressed the throttle will close, and second, when the Transbrake Push-
button is pressed the throttle will close. Once the Starting Line Enhancer is engaged the driver can then fully press the gas
pedal. The throttle stop limits the engine RPM to a preset amount. After the throttle has been closed the Starting Line
Enhancer will open the throttle at the programmed amount of time before or when the Transbrake solenoid is released.
Crossover Delay = 01.35
Starting Line Enhancer = 00.40
Timer 1
= 1.000
Timer 2
= 2.000
Timer 3
= 08.00
Timer 4
= 00.50
Setting the
Starting Line Enhancer Mode
Press the 4 key, to bring up the Starting Line Enhancer setting. The number shown on the right screen represents the
mode the Starting Line Enhancer is in. If 1 thru 5 is displayed the Starting Line Enhancer is turned on, if a 6 is displayed, the
Starting Line Enhancer is turned off. The list below shows what each mode number means.
Using Mode 1 will release the SLE 8 tenths of a second before the Transbrake releases.
Using Mode 2 will release the SLE when the Transbrake releases.
Using Mode 3 will release the SLE when the Transbrake Push-button is released.
Using Mode 4 will release the SLE when the Transbrake Push-button is engaged. (This is used in pro light racing)
Using Mode 5 will release the SLE one second before the Transbrake releases.
Using Mode 6 will turn off the SLE.
To change the Starting Line Enhancer mode, first use the 2ND key to move the selection arrows to the right side of
the screen. Then use the Up or Down arrow keys to change the Starting Line Enhancer mode to the desired number.
The Elite 95 uses the Throttle Mode setting to control whether the output on the terminal strip for the Starting Line
Enhancer is putting out 12 volts or taking 12 volts away when activated. To change the output voltage setting follow the
instructions for Setting the Throttle Mode on page 9.