Digital Alert Systems
MultiPlayer Quick Start Guide
Revision 4.0
Page 11 of 13
8.
Switch to the
Setup > Audio > Audio Output Levels/Test
tab
9.
Ensure the
Audio Output Sample Rate
is set at
16000 Sample/sec
by selecting it in the pull-
down menu.
(Note: This merely sets the sampling rate for the monophonic EAS audio and
DOES NOT
impact
the AES input and output rates.)
Figure 11 Setting the audio sample rate for EAS audio. See text for more information.
10.
Once selected the change is immediately applied.
11.
If you are using Analog Audio for the MultiPlayer, you must set the
EAS Header/Tone/EOM
Amplitude percent
to 40. Once you have changed the value press enter. The changes will be
applied.
12.
If you have changed the
EAS Header/Tone/EOM Amplitude percent
from the default value of
80
, you must go to the
Setup > Audio > Multiplayer
page. Scroll to the bottom and click the
Init
Multiplayer
button. This will load a new Attention Signal and End of Message Tone, using the
new amplitude percent you have set.
Ensure this selector is set
at 16000 Sample/sec
