6
Network Installation
•
Connect an RJ-45 cable between the Ethernet 10/100
connector and a network switch or directly to a PC for
configuration
•
After the Ethernet 10/100 is connected, another IP device
can be connected to Port 2 10/100
Mounting Instructions
The IP7 series is design to be mounted on standard 35mm
DIN rail or surface mounted using the optional surface
mounting plate.
•
DIN Rail Clip
– Tilt top of unit (J1, J2 connectors facing up
with Volume buttons facing forward) back towards the DIN
Rail until the IP7-SE8 DIN clip catches the top of the rail.
Press in at the bottom of the IP7-SE8 to snap into place.
•
Surface Mount Plate
– Snap the optional surface mount
plate in half and secure it to the back of the frame using
the provided screws so that the mounting holes extend
past the edges of the case
