DG-BR1000Nu User Manual
67
ISP that the wireless settings of the access point is
changed, please configure the router in this page to
match the settings.
staEnable: Enable this function and the router can only
allow to be connected through wired Ethernet cable for
WAN access service.
SSID
This is the name of wireless network. Input the SSID
name that your wireless ISP has provided you with.
Site Survey
Click ‘Select Site Survey’ button, then a “Wireless Site
Survey Table” will pop up. It will list all available
access points nearby. Select the access point designated
by your wireless ISP in the table and the router will join
wireless network through this access point.
Security Setting
If the access point enables wireless security, you have to
follow the same settings in order to access the access
point. Click to set security settings for this connection
section ‘2-8-3 Wireless Security’
detailed instructions).
MAC
If your service provider binds your internet connection
with a specific MAC address then enter a MAC address
in the format 010203040506.
Clone MAC
Click this button if you want to clone the WAN port
MAC address of the router with that of the PC.
After you finish with all settings, please click ‘Apply’ button and the following
message will be displayed on your web browser:
If you want to reset all settings in this page back to previously-saved value, please
click ‘Cancel’ button
Please click ‘Continue’ to go back to previous setup menu; to continue on other setup
procedures, or click ‘Apply’ to reboot the router so the settings will take effect (Please
wait for about 30 seconds while router is rebooting).
