Spear - Pool, Pond & Garden Fixture
Installation Guide
digilin.com.au
+617 3899 1267
Page 2 of 3
Installation
1.
Press stake into ground with light
roughly aligned in desired direction.
2.
Run continuous cable from luminaire back to
dry location to make any joins and connect
to power supply/further fittings.
If insufficient cable has been ordered with
the luminaire, a waterproof cable join, using
an approved waterproof cable joining kit in
accordance with Wiring Regulations must
be undertaken.
3.
Turn on power.
4.
Adjust fitting tilt to desired angle.
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at
