LDR-CV-15A-1CH - High Current PWM Repeater
User Manual
3.0 - 24 November 2020
Page 3 of 3
+617 3899 1267
Inputs
U n i t s
Voltage
12 - 24
VDC
Communications
Low side Switched PWM
PWM Input Current Draw (max)
20
mA
Outputs
U n i t s
Outputs
1 Channel Low side PWM
Current Per Channel
15
A
Fuse
20
A
Installation
1. Open Enclosure
To access the wiring terminals, remove the top plate by first removing the 4 screws securing it.
2. PWM Input
Connect a low side switched PWM source (such as a single channel from the LDMX-PWM-4) to the PWM In
pins. The PWM in pins are optically isolated from the rest of the circuit.
3. LED Fitting
Wire the LED fitting(s) to the output port of the LDR.
4. Power
Connect the input voltage to the Power +/- Pins. This is also the power to the LED fitting(s) as such it
should be selected to match the power requirements of the fitting.
5. Close Enclosure
Replace the top panel (making sure of correct orientation) and secure it with the 4 screws.
Appendix A. Wiring Diagram
