Installation Instructions
Mounting
When mounting or connecting the amplifier always disconnect it from the mains.
Use four screws and washers when mounting the amplifier to the front rack rails. Rear
support is also provided. Always mount the amplifiers rear support points to a suitable rear
support rail.
Cooling
Under normal operation of the power amplifier, overheating should never be a problem. The
air is taken in from the front and out through the back. It is of course essential that while the
power amplifier is running air is able to circulate around it freely.
The efficiency of the cooling will depend on the immediate environment. If the amplifier is
installed in a case, the open area at the back of the case must be at least 140 cm². The area
should be in line with the cooling vents of the amplifier. If this can not be achieved a forced
ventilation system has to be used.
Please clean the dust filters on a regular
basis. For this process unscrew and
remove the filter covers and take off the
dust filters to clean or replace them.
Do not place wet or dump dust filters in the
unit.