Wiring
XLR connection
Pin 1 : Ground
Pin 2 : Hot (in phase)
Pin 3 : Cold (out of phase)
Always use symmetrical (balanced)
shielded cable to connect the amplifier.
The Ground Lift and Input Sensitivity
can be enabled via the DSPNET
network software (see “Software” on
page 17).
Speakon connection
Both Speakon connectors are connected to channel A and channel B outputs.
Channel A Output:
Pin 1 + Channel 1 speaker signal
Pin 1 - Channel 1 speaker ground
Pin 2 + Channel 2 speaker signal
Pin 2 - Channel 2 speaker ground
Channel B Output:
Pin 1 + Channel 2 speaker signal
Pin 1 - Channel 2 speaker ground
Pin 2 + Channel 1 speaker signal
Pin 2 - Channel 1 speaker ground
WARNING:
Speakon terminals marked with the lightning flash
carry hazardous voltages. To prevent electrical shock, do not
operate the amplifier with any of the conductor portion of the
speaker wire exposed.
Speaker cabling
Larger wire sizes and shorter lengths minimize both loss of power and degradation
of damping factor. Do not place speaker cables next to input wiring.