5.3 Fixing to the floor
The image below indicates the fixing points on the floor.
The surface must be steady and leveled to ensure good alignment of the sensors.
Fixing can be done through anchor bolts, also known as parabolts, through chemical
fixing.
5.2
Preparation for fixing
Before installing block
, check:
dGate
1. The place chosen for installing the equipment;
2. If there is a power source or electric socket nearby (ducts for connection).
3. If the place chosen is adequate for the installation of the access controller (indoors).
4. If the floor has conditions to receive anchor bolts (at least 4cm of
15 M.P.A.
FCK
concrete or equivalent).
ATTENTION:
Once the block dGate installation requires floor drilling, it is
extremely important that the place of installation be chosen carefully.
INFORMATION:
Measures of the blocks dGate are illustrated in millimeters
and (Inches)
.
TIP:
To fasten the screws, use a tool with a long extensor.
-
Fixing points
10
Optional fixing points
70
(2.755")
1309
(51.535")
1416
(55.748")
159
(6.259")
320
(12.598")
320
(12.598")
130
(5.118")
130
(5.118")
240
(9.448")
Ø
15
(0.590")
90
(3.543")
84
(3.307")
220
(8.661")
220
(8.661")
220
(8.661")
