3.4
Description
W
REPORT AT CONNECTION
W0
When connected the modem displays:
CONNECT and the digital rate.
W1
When connected the modem displays:
Line Speed,Error Correction Protocol (if any),Digital rate
W2
When connected the modem displays:
CONNECT and line speed.
Default=W2
X
DIAL TONE DETECTION
X0
Busy and dial tone detect disable. OK and ERROR code enable.
X1
Busy and dial tone detect disable. OK and CONNECT xxxxx code enable.
X2
Dial tone enable only. OK, NO DIAL TONE and CONNECT xxxxx enable.
X3
Busy tone enable only. OK, BUSY and CONNECT xxxxxx enable.
X4
Busy and dial tone enable OK, BUSY, NO DIAL TONE and CONNECT xxxxx enable.
Default=X1
Y
BREAK DISCONNECTION
Y0
Disable long space disconnect.
Y1
Enable long space disconnect. In non-error correction mode or in buffer mode, the modem will send
a long space of four seconds prior to going on-hook. In error correction mode, the modem will send
respond to the receipt of a long space (a break signal greater than 1,6 seconds) by going on-hook.
Default=Y0
Z
RESET AND LOAD USER PROFILE
Z0
Reset and load user profile 0.
Z1
Reset and load user profile 1.
+MS=
MODULATION FORMAT
This extended-format command selects the modulation, optionally enables or disable
automode, and optionally specifies the lowest and highest rates using one to four
subparameters. the command format is:
AT+MS=[mod],[automode],[min_RXrate],[max_RXrate],[law],0,[max_TXrate]
# [mod]
= modulation type
# [automode] = automode enable or disable
# [min_RXrate] = min Receive speed
# [max_RXrate] = max Receive speed
# [law]
= 0 for USA
= 1 for Europe
0
= fixed value (do not modify)
#[max_TXrate] = max Trasmission speed
l
Modulation type (see the below table)
SNM7003.pm6
4/8/98, 14:46
4