Regulatory information and certifications
Bluetooth SIG-qualified hardware and firmware
ConnectCore 6 Plus Hardware Reference Manual
104
OEM labeling requirements
The
CE
marking must be affixed to a visible location on the OEM product.
CE labeling requirements
The CE mark shall consist of the initials
CE
taking the following form:
n
If the CE marking is reduced or enlarged, the proportions given in the above graduated
drawing must be respected.
n
The CE marking must have a height of at least 5mm except where this is not possible on
account of the nature of the apparatus.
n
The CE marking must be affixed visibly, legibly, and indelibly.
Declarations of Conformity
Digi has issued Declarations of Conformity for the ConnectCore 6 Plus module concerning emissions,
EMC, and safety. For more information, see
http://www.digi.com/resources/certifications
Important note
Digi customers assume full responsibility for learning and meeting the required guidelines for each
country in their distribution market. Refer to the radio regulatory agency in the desired countries of
operation for more information.
Approved antennas
The same antennas have been approved for Europe as stated in the FCC table for use with the
ConnectCore 6 Plusmodule.
Bluetooth SIG-qualified hardware and firmware
The ConnectCore 6 Plus is qualified by the Bluetooth SIG.
At the hardware level, the ConnectCore 6 Plus is listed as a Controller Subsystem under the following
identifiers:
n
QD ID # 101838
n
Declaration ID # D037484
The Digi BlueZ Bluetooth library in the Linux firmware is listed as a Host Subsystem under the
following identifiers: