15
1. Remove the shipping banding from around the Telescopic Piling and Drilling Extension.
2. Remove any attachments from the front of the machine.
3. Following all standard safety practices and the instructions for installing an attachment in your machine operator’s manual, install
the Telescopic Piling and Drilling Extension your machine.
4. Lower the unit to the ground and remove the key from the parent machine.
5. Relieve any pressure from the auxiliary hydraulic system and after making sure that there is not any foreign matter on the hydraulic
couplers, connect the power and return couplers to the auxiliary hydraulic system of your machine.
6. Route the hoses in such a fashion as to avoid pinching or chafing.
7. Carefully raise the loader and cycle the tilt cylinders to check clearances and to verify that all mounting procedures have been
successfully completed. The machine and attachment are now ready for use.
The DIGGA Telescopic Piling and Drilling Extension attaches to the tool bar/quick-attach mechanism of your machine. Due to this
arrangement, thorough knowledge of the machinery controls is necessary for machine operation. Read and understand your machine
operator’s manual for information regarding machine operation before attempting to use the Telescopic Piling and Drilling Extension.
When a Telescopic Piling and Drilling Extension is purchased from Digga or a DIGGA Dealer/Distributor the frame/attachment is matched
for suitability and compatibility to the original machine it was purchased for. For fitment of the Telescopic Piling and Drilling Extension
to other machines you must first contact your DIGGA dealer and receive written confirmation to ensure you do not incorrectly fit the
Telescopic Piling and Drilling Extension to a machine it wasnt designed for. Warranty will be void if the Telescopic Piling and Drilling
Extension is fitted to an alternative machine without first receiving written confirmation from your DIGGA dealer. Check the work site
and identify the extent of the work to be carried out and note any possible hazards or constraints. Underground cables, services etc.
Check with relevant government departments on the location of these before commencement of any work. Review the job at hand and
determine the Telescopic Piling Extension is appropriate for the intended work and conditions.
7 INSTALLATION AND OPERATING INSTRUCTIONS
NOTE: IT IS IMPORTANT TO MAKE SURE THE LOCKING MECHANISM ON YOUR QUICK ATTACH IS ENGAGED,
THEREFORE LOCKING THE ATTACHMENT ONTO THE MACHINE.
INSTALLATION INSTRUCTIONS
ATTACHING DRIVE UNIT
1. Position the Telescopic Piling and Drilling Extension
flat on the ground with the linkage pointing forward.
2. Align the holes of linkage to the hole in the ears of
the drive unit. Insert the pin through the ears and
linkage and secure with lynch pin.
PIN
LYNCH PIN
