Digga PR3843, Installation, Operating And Troubleshooting Manual, Page: 11 / 32

5
.
Turn the hubs power on.
Make sure the power switch
has a solid red light. If the
light is flickering or does not
come on there is a problem.
Give the hub some movement
by patting it with your hand or
movement with the drive. This
wakes the hub up.
6
.
Turn display power on.
Check for solid red light on
the switch.
Make sure the power cable is plug ged securely into the power connections and the cable is
not going to be caught on anything. Wait for the display to load.
Once the display is running go to the “menu” button, then to “connect to pin or hub” button.
You will see a white screen with “please wait…” connecting may take a couple minutes.
A screen will come up with a hubs serial number, highlight it and “connect” button. Do not
select “channels” that is for multiple hub connections. Sometimes for difficult connection s,
removing the display from the ball mount assembly can help speed up connection. Replace it
when you are connected. Note: If a “failed to connect” message comes up go back to the main
display and wait, the display and hub are exchanging data and they will connect.
You will know if the hub is connected when you see the hubs serial number in the top middle
of the main screen. The battery charge will appear under it. You may also see some torque
fluctuation in the gauge. Some noise is normal operation. Some torque may show depending on
how tight and even the adapter was installed. Note: The process of connecting is faster if the
hub and display stay together as a unit. Displays and hubs can be mix and matched but
connecting may take longer when this is done.
TORQUE HUB INSTALLATION
11
PM-000 199 September 20 19