
WARNING!
WARNING!
WARNING!
WARNING!
EQUIPMENT SAFETY PRECAUTIONS
KNOW WHERE UTILITIES ARE
Observe overhead electrical and other utility lines. Be sure equipment will clear
them. When digging, call your local utilities for location of buried utility lines, gas,
water and sewer, as well as any other hazard you may encounter.
EXPOSURE TO RESPIRABLE CRYSTALLINE SILICA DUST
ALONG WITH OTHER HAZARDOUS DUSTS MAY CAUSE
SERIOUS OR FATAL RESPIRATORY DISEASE.
This attachment is designed to plane (mill) rock, concrete and asphalt, causing high
levels of dust. It is recommended to use dust suppression, dust collection and if
necessary personal protective equipment during the operation of the planer or of any
attachment that may cause high levels of dust.
REMOVE PAINT BEFORE WELDING OR HEATING
Hazardous fumes/dust can be generated when paint is heated by welding, soldering
or using a torch. Do all work outside or in a well ventilated area and dispose of paint
and solvent properly. Remove paint before welding or heating.
When sanding or grinding paint, avoid breathing the dust. Wear an approved
respirator. If you use solvent or paint stripper, remove stripper with soap and water
before welding. Remove solvent or paint stripper containers and other flammable
material from area. Allow fumes to disperse at least 15 minutes before welding or
heating.
END OF LIFE DISPOSAL
At the completion of the useful life of the unit, drain all fluids and dismantle by
separating the different materials (rubber, steel, plastic, etc.). Follow all federal, state
and local regulations for recycling and disposal of the fluid and components.
OPERATING THE P
ROFILER
•
Block off work area from bystanders, livestock, etc.
•
Operate only from the operator’s station.
•
Reduce speed when driving over rough terrain, on a slope, or turning, to avoid
overturning the vehicle.
•
An operator must not use drugs or alcohol, which can change his or her
alertness or coordination. An operator taking prescription or over-the-counter
drugs
should seek medical advice on whether or not he or she can safely
operate
equipment.
•
Before exiting the prime mover, lower the attachment to the ground, turn off the
prime mover’s engine, remove the key and apply the brakes.
•
Be sure all doors, guards and shields are in their proper position and securely
attached before operating the p
rofiler
.
WARNING!
PM-000068-A DECEMBER 2017
7
Summary of Contents for HP450
Page 1: ...OPERATOR S MANUAL HP450 HP600 ROAD PROFILERS FOR SKID STEER LOADERS PM 000068 A DECEMBER 2017...
Page 2: ...THIS PAGE IS INTENTIONALLY BLANK PM 000068 A DECEMBER 2017...
Page 4: ...THIS PAGE IS INTENTIONALLY BLANK PM 000068 A DECEMBER 2017 2...
Page 36: ...THIS PAGE IS INTENTIONALLY BLANK PM 000068 A DECEMBER 2017 34...