This screen allows the user to select one of two modes, Local Mode or Remote Mode.
Local Mode:
(default) The LEIT XRC controller is not listening to a signal from the LEIT Link handset and radio
power is conserved.
Remote Mode:
Enables the LEIT XRC controller to scan for a signal from the LEIT Link handset. Select Remote
Mode only when using the LEIT LINK handset
To select the mode, press
or
to underscore one of the
two modes, then press
to select. Press
or
again
to underscore OK. Press
to continue.
This is followed by the Are you Sure screen to confirm the option that
has been selected.
Press
or
to underscore Yes or No, then press
to
select. Press
or
again to underscore OK. Press
to continue.
The Controller ID is used as an individual identity address for a single
controller and handset within a group of controllers. The Controller ID
allows the user to link to a single controller, via the handset. On first
contact, the Select ID screen displays two numbers that allow for a
number from 1-99 to be entered as the controller’s identity address.
The user must enter the identity address into the controller.
To set a controller ID, press
or
and underscore one of the ID numbers. Then press
or
to select the ID number. Repeat the steps with the second number to select a controller ID. Press
or
again to underscore OK. Press
to continue.
NOTE:
Do not change the group ID from 01 unless LEIT Link
Master is used
This option is available on the LEIT Link MASTER only.
The Group ID Number allows the handset to link to a controller within
a group of controllers, which have the same Group ID. This gives the user the flexibility to address an individual
controller in a group of controllers by location or area.
Press
or
to underscore one of the two numbers then, press
to select a number. Repeat the
steps with the second number to select the Group ID, then press
or
to underscore OK. Press
to continue.
In this screen the user can limit the controller radio operation time to daylight hours to prevent power drainage
from the controller. Our suggestion is 8AM-5PM. This will allow the controller to operate in a window of early
mornings to late afternoon.
The LEIT XRC requires greater energy for radio communication. In order to retain sufficient
energy to maintain valve control the radio on the controllers will automatically turn off in low
light conditions.
To set the Radio On, underscore the hour digits using
or
and press
or
to change the
setting. Repeat the steps for changing the minute digit and AM/PM and when finished press
or
again to underscore OK. Repeat the steps for Radio Off. Press
to continue.
24
l
Local Mode
Remote Mode
Are you Sure?
l
Yes No
Cont. ID: 12
Group ID: 01
Radio: 05:00pm
Off
Radio: 08:00am
On
