C U B E 3 0 T O U C H - U S E R M A N U A L
Rev 1.1 07/2018
51/56
CONNECTION TO HOST COMPUTER
Communication between the CUBE 30 touch and an external computer can
be established:
1- Using a USB connection:
Connect a standard A-
B USB cable between the computer’s USB port
(type-A rectangular connector) and the CUBE 30 touch
’s USB port
(type-B square connector). The driver (STM32 SW; download from
www.diesse.it) for MS Windows will need to be installed to establish
communication with the CUBE 30 touch through a virtual COM port on
USB.
On the Cube 30 touch
, in the Service menu, the “HOST BY USBD”
parameter must be set to ON.
2- Using a serial RS232 COM on the PC.
Connect a straight standard serial cable between the PC’s RS232
COM port and the
instrument’s RS232 (9-pin) serial connector.
On the Cube 30 touch
, in the Service menu, the “HOST BY USBD”
parameter must be set to OFF.
The electric levels of the signals are all the standard RS232C type.
-
The default transmission speed is 9600 bit/s
-
the data format is 8-bit,
Chapter
8
