Operating Manual Program Timers Variotime Single and Variotime Twin
Diehl AKO Stiftung & Co.KG, Appliance Europe, Pfannerstraße 75-83, DE – 88239 Wangen
Tel. +49 (7522) 73-0 • Fax +49 (7522) 73-250 •
• www.diehl.com/controls/appliance
Subject to change without notice – issued 04-2015 – page 14/20
pressing the skip button
once selects channel 1. The channel indicator 1 flashes. After
approximately 3 seconds, 1 stops flashing and the light bulb symbol
appears.
pressing the skip button
twice selects channel 2. The channel indicator 2 flashes. After
approximately 3 seconds, 2 stops flashing and the light bulb symbol
appears.
The order of setting the channels is not important. If both channels are in continuous
operation mode, the display will show “12” and the light bulb symbol
steadily.
3.
Terminate the continuous operation mode of both channels by setting the slide switch to
the position AUTO.
The timer resumes the automatic program and displays the present status accordingly.
Change a current setting by terminating first and resetting again.
3.2.2 Deactivation mode
In this mode, the appliance in which Variotime is installed is switched off continuously. Any
automatic program is deactivated.
Variotime Single
Proceed as follows:
1.
Set the left-hand slide switch to position 0.
The relay switches off if it was on before. On the right side of the time digits, 1 (= channel
1) flashes as long as this mode continues.
2.
Reactivate the automatic program by setting the left-hand slide switch back to position
AUTO.
The timer resumes the automatic program and displays the present status accordingly.
Variotime Twin
In this version, both channels can be deactivated independently. Possible combinations are:
•
channel 1 deactivated and channel 2 unchanged
•
channel 2 deactivated and cannel 1 unchanged
•
Both channels deactivated
Proceed as follows:
1.
Set the left-hand slide switch to position 0.
