• 6 •
5.2 USING THE WORK LIGHT
The work light is controlled by an
ON/OFF switch located on the
front of the unit.
1.
Make sure the lamp is turned
OFF when the unit is being
recharged or stored.
2.
Position the unit on a flat,
stable surface near the
intended work area.
3.
Ensure the battery clamps are
securely clipped on the storage
holders.
5.3 POWERING A 12V DC DEVICE
The unit is a power source for
all 12V DC accessories that are
equipped with a 12V accessory
plug. Use it for power outages and
on fishing or camping trips.
NOTE:
Do not power a 12V device
with the unit while charging the
internal battery.
1.
Make sure the device to be
powered is OFF before inserting
the 12V DC accessory plug into
the 12V DC accessory outlet.
2.
Open the protective cover of the
DC power outlet on the unit.
3.
Plug the 12V DC device into
the DC power outlet and turn
on the 12V DC device (if
required).
4.
When finished, turn off the DC
device (if required) and unplug
from the DC power outlet.
CAUTION:
Do not use the unit
to run appliances that draw more
than 20A DC.
NOTE:
Extended operation of
a 12V DC device may result in
excessive battery drain. Recharge
the unit immediately after
unplugging the 12V DC device.
Estimated run-times
APPLIANCE TYPE
EST
WATTAGE
EST
USAGE
Cell phone
4 watts
13 hrs
Fluorescent light
4 watts
15 hrs
Radio, fan,
depth finder
9 watts
6.7 hrs
Camcorder
15 watts
4 hrs
Electrical tool
24 watts
2.5 hrs
Electric cooler
48 watts
1.3 hrs
Car vacuum,
air compressor
80 watts
0.8 hrs
NOTE:
Actual time may vary. Times are
based on the internal battery being fully
charged.
6. MAINTENANCE INSTRUCTIONS
6.1
After use and before performing
maintenance, unplug and
disconnect the jump starter.
6.2
Use a dry cloth to wipe all battery
corrosion and other dirt or oil from
the battery clips, cords and the
jump starter case.
6.3
Ensure that all of the jump starter
components are in place and in
good working condition.
6.4
All servicing should be performed
by qualified service personnel.
7. MOVING AND STORAGE INSTRUCTIONS
7.1
Store inside, in a cool, dry place.
7.2
Do not store the clips on the
handle, clipped together, on or
around metal, or clipped to cables.
The clips on the jump starter are
live and will produce arcing or
sparking if they come in contact
with each other. To prevent
accidental arcing, always keep the
clips on the storage holders when
not using it to jump start a vehicle.
7.3
If the jump starter is moved around
the shop or transported to another
location, take care to avoid/
prevent damage to the cords, clips
and jump starter. Failure to do so
could result in personal injury or
property damage.
