12
USINg ThE QUICK-DISCONNECT CABLE CONNECTORS
Connect any of the three output cable assemblies to the charger in
seconds. Make sure to place the charger on a dry, non-
flammable surface.
NOTE:
Never connect the clamp and ring terminal connectors
together for use in other applications, such as external battery or
other power source charging, or to extend the output cable length, as
reverse polarity and/or overcharge conditions will occur.
50 AMP BATTERY CLIPS
Connect the end of the charger output cable to the end of the
1.
50 Amp Battery clips cable.
Follow the steps in sections 6 and 7 to connect the output
2.
clips to the battery.
After a good electrical connection is made to the battery, plug
3.
the power cord into a 3-prong grounded 120V AC electrical
wall outlet. Make sure to place the charger on a dry, non-
flammable surface.
PERMANENT RINg CONNECTORS
The ring connectors permanently attach to the battery providing easy
access to quickly charge your battery. This application is appropriate
for motorcycles, lawn tractors, ATVs and snowmobiles.
To permanently attach to a battery, loosen and remove each
1.
nut from the bolt at the battery terminal.
Connect the red POSITIVE connector ring to the POSITIVE
2.
battery terminal.
Connect the black NEGATIVE connector ring to the
3.
NEGATIVE battery terminal.
Replace and tighten the nuts to secure.
4.
Connect the cable to the end of the charger output cord.
5.
Take care to keep the wires and plug away from metal and
moving parts.
Plug the charger power cord into a 3-prong grounded 120V
6.
AC electrical wall outlet. Make sure to place the charger on a
dry, non-flammable surface.
Summary of Contents for 28.71219
Page 2: ......
