The selection of the correct wire-temperature-coefficient is very important for the
correct operation of the mod, when temperature controlled vaping is selected.
The mod provides predefined coefficients in the main menu for wire types NiFe30
All dicodes devices have a functionality to adjust the minimum discharge level of the
battery between 2.5V and 3.0V (older models 3.5V). Almost all available batteries on
the market specify the minmum discharge level of 2.5V to 2.7V. If the user is unsure,
whether the specific battery meets this specification, the level should be set to 2.7V.
The time to automatic power off of the mod can be selected between 1 minute up to
60 minutes. We recommend to choose 2 or 5 minutes in conjunction with immediate
vaping enabled (”OnClick”=0). This is the best utilization of the battery. In this
combination, though, there is one situation to be considered: If the mod is transported
in a bag, e.g., and the button is accidentially pressed all the time, it theoretically could
happen that the mod exceeds the maximum vape time, error 7, goes into auto power
off, is immediatle switched on again and so forth in an endless loop.
In the following paragraphs, explanations are given for those parameters and items, which are not self
explanatory or which have inter-dependencies with other parameters or functions.
06 Extended Functions Menu
Additional Explanation to several menu items, page 1
(dicodes wire), Ni200, Titanium, Stainless Steel SS316L and Stainless Steel SS304 (Inox). If “Other”
is selected as wire type, the value of this parameter is used as the temperature coefficient. The
parameter can be found in the Extended functions menu/Heater Menu/TempCof. The TempCof item
in the menu is visible, even if the operation mode selected is not temperature controlled vaping.
The selected voltage is the voltage at the input of the electronics, when current is drained from the battery
and includes any contact- or other resistance voltage drops. The current drained depends
on the power at the coil and the battery voltage. In contrast to other available tube- and box-mods on
the market, which stop operation already at 3.4V, the lower discharge level on dicodes mods lead to a
better battery utilization (up to 20%).
Note that the mod might start reducing the power output at a battery level of Ubat,min + 0.5V. The
reduction is indicated by a changing display of battery symbol an “LOW”.
The picture shows the
operation of the power
reduction. The reduction
depends on the power
setting and Ubat,min.
The limiting slope always
starts at 10W and Ubat,min
and stops at 80W and
Ubat,min + 0.5V.
To overcome this potential problem, the mod has an implemented secure behaviour:
If “OnClicks”<2
Error 7 (TimeOut) happened
the mod has an auto-power-off, the mod can only
be switched on again by pressing the button short term 5 times.
This behaviour happens only one time. Afterwards the operation is as selected by the user. The 5 OnClicks
is also activated, when “Onclick”<2
the devices is actively switched off by the user
(not auto-power-off).
As indicated, the OnClick range is from 0 (immediate vape) to 5. Note that the mod is always on after the
first click, and then detects whether the selected number of clicks is performed in a certain time. If this is
not the case, it switches off immediately.
AND
AND
AND
Summary of Contents for Dani 25
Page 1: ...manual Dani 25 ...
