The Dani 25 can be used in 5 different modes. But in order to keep the menu
as short and simple as possible, 3 of the 5 modes are only available, if the Expert-Mode
is set to 1. The name is Expert-Mode, because the use of the additional operation modes
requires additional knowledge about their functionality.
06 Extended Functions Menu
Weitere Erläuterungen zu einzelnen Punkten im Extended Functions Menü Seite 2
06 Extended Functions Menu
Additional Explanation to several menu items, page 2
The display mode switches on and off the dynamic display of several parameters during
the vape.
With display mode =cont (continuous) or post and temperature controlled mode, these
parameters are the temperature, coil resistance, temperature regulating power and
battery voltage.
For the modes standard, boost and heater protection the selected power (static, no change), the coil
resistance and the battery voltage are displayed. When Bypass mode is selected, the coil resistance and
battery voltage dependent, calculated power is displayed, as there is no fixed power setting in bypass
mode. Withdisplay mode =cont the value are displayed during and after the vape, with “post” they are
display only after the vape.
When display mode =off the display is off during and after the vape..
The additional modes available with Expert Mode set to 1 are “Power Boost”, “Heater Protection” and
“Bypass”.
Here again the modes in an overview:
- Standard:
Vaping with a constant power setting. The selected power is applied to the coil, unless the
coil’s resistance affords a different power setting.
- Temperature The power applied to the coil is calculated by a temperature controller, which keeps the
Control:
coil’s temperature constant. Important to note: Set the right temperature coefficient and
perform a calibration at room temp.
- Heater
The power to the coil is repetively interrupted to enable a liquid flow und to limit the
Proection:
temperature.
- Power Boost: The coil is quickly heated up initially. Moreover an repetitive boost can be
selected. Note to not to set the power limit to a value too low and use
lower normal power setting.
- Bypass:
The mod behaves like a mechanical mod, i.e. the battery voltage is directly applied to the
coil, with the restriction, that the maximum current is limited to 20A. Note that the
vape now depends on the charging level of the battery.
The Power Limit has an effect on several functions of the mod:
1. Power Limit defines the adjustment range of the power in the main menu. As stated
in the main menu already, the limit value sets the roll-over point of the menu items
“Power Up” und “Power Down”. The power limitation makes sense especially in the standard vaping
mode and the use of small atomizers or coils, to avoid a coil break.
2. Power Limit sets the power during the boost-phase in the Power Boost Mode.
Summary of Contents for Dani 25
Page 1: ...manual Dani 25 ...
