05 Main Menu (Page 5)
Error Messages
If an error occurs, the mod directly jumps to the error menu and displays the error
number and a mnemonic (short-term) description.
The possible error messages are:
0 OvrVolt:
The input voltage is too high. The Dani 25 is prepared for the
use of one battery. If the input voltage exceeds 4.5V this error message
is displayed. Reduce the input voltage to the specified range.
1 ChkAtom: No atomizer detected or open coil.
2 TempRef: A problem during the temperature reference measurement occured
Repeat the calibration procedure.
4 OverCur: Short on coil or coil breakdown (open)
5 LowBat:
The battery voltage under load (with current drained from it) has reached
the minimum discharge level, defined with parameter UbatMin in the
extended function mod-menu.
6 EleHot:
The electronics have heated up too much and needs to cool down. This
error will not occur with normal usage of the mod.
7 TimeOut: The maximum puff-time is limited depending on power. For a power <20W
it is 20seconds. Above 20W it decreases by 0.5seconds per Watt. And from
40W it is kept at 10seconds.
Important remarks on the Use of Dani 25
1. The Dani 25 is capable to heat up the coil with 80W of power. With 80W continuous power, the coil
will heat up to temperatures far beyond the recommended maximum temperature of 240°C. So we
do not recommend vaping at permanent wattages beyond 60W.
2. Always keep in mind that 80W taken even from a high drain battery will create power losses in the
batteries inner resistance as well as at all mechanical contacts, which finally will reduce the total
vape time and lead to volt drop. To reduce the contact resistance from the battery-bottom to the
electronic/tube, the Dani 25 is equipped with an ultra-low-ohmic, multi-contact copper-beryllium
spring inside the battery cap. This spring provides 8 contacts to the battery and 16 contacts to the tube.
All of the current is flowing directly from the battery to the tube and not (as on other tube-mods)
through the threads and spring of the bottom cap. The typical resistance from the battery to the
tube is just 0.7mOhm.
Nevertheless, when vaping at 80W, the user must accept voltage drops inside the battery of up to
0.6V (assumed 3.1V at battery including drop, 25mOhm inner resistance, 80W power).
3. If a power of >60W is selected, we recommend to set the Ubat,min value to 2.7V (default) or greater.
This will prevent battery currents >25A. Due to the volt drop at high currents, the electronic might
reduce power at voltage levels of Ubat,min + 0.5V (please see diagram below at Ubat,min explanation).
4. We recommend to use the Dani 25 with temperature controlled vaping or in boost operation mode,
because in both modes the average power applied to the coil to achieve the best vaping result is
most probably below 60W.
Big coils with a high thermal mass may require a high initial power of 80W until the coil heats up.
But once it is hot, the power to keep the temperature is much lower. In both recommended
operation modes, the danger of reaching too high temperatures and the generation of hazardous
substances is minimized.
Summary of Contents for Dani 25
Page 1: ...manual Dani 25 ...
