Dickey-John Flex4, Operator'S Manual

Page: 26 / 152

OPERATOR’S MANUAL
Figure 19
Rate Control Module Harness
RATE CONTROL MODULE HARNESS
1. Connect the Rate Control Module harness to the mating connector of
the cab harness (use an extension harness if additional length is
needed).
2. Secure harness as needed.
3. Connect the module harness to the mating connectors of the CAN/
power backbone, if used. The Rate Control Module uses a 30 and
18-way connector with a jackscrew to secure the connector to the
module. The output module uses a pair of 12-pin connectors.
4. Secure module harness as needed.
Rate Control
Module
Cab or
Terminator Electric Pump
Extension
Driver Harness,
Harness
PWM Ch 4 Aux S/Spinner
PWM Ch 3 Granular
PWM Ch 2 Auxiliary
PWM Ch 1 Liquid
CH4 Spinner Feedback
CH1 Liquid Feedback
CH2 Auxiliary Feedback
CH3 Granular Feedback
Ground Speed
Remote On/Off
Joystick
Extension Harness,
or Output Module
Digital 1 Sensor
Harness
Digital 2 Sensor
Hopper Level Sensor
Remote Blast
Ch2 Pressure/Bed Height (Analog 1)
Down Pressure Sensor (Analog 4)
Gate Height Sensor (Analog 3)
Flex4 Interface cable
Scraper
Servo 1
Liquid
Servo 2
Auxiliary
attaches to any of the
analog 1 ‐ 4 connectors.
RoadWatch Temperature
Sensor Adapter connects to
the Flex4 Interface cable.
Tank Level Sensor (Analog 2)
Boom Section
Flex4 Pro
TM
Control System
6010541 Rev A
INSTALLATION / 23