Diamondback 910IC, Owner'S Manual, Page: 12 / 36

12
• Insert the handlebar/stem assembly ( B-21 ) into
the receiver on the main frame, paying care
not to pinch the wire harness connector (
B-17 ).
•
Loosen the stem height adjuster knob ( G-6 )
with two or three counter-clockwise rotations.
Adjust the stem/handlebar assembly to the
lowest position by pulling outward on the knob
to disengage the pop-pin. If the stem assembly
does not drop, loosen the knob further and
pull outward on the knob again. Repeat these
steps again if necessary.
• Install the saddle ( L ) onto the seat post and
tighten with the included wrench.
•
Install the pedals ( F-L & F-R ) onto the cranks by
threading the left pedal by hand (marked with
an “L”) into the left crank with a
counter-
clockwise rotation. Do not cross-thread the
cranks/pedals. The pedal must be tight and
installed completely to prevent future damage
to the cranks.
•
Repeat the pedal installation steps for the right
side, noting that the pedal will thread into the
right crank with a
clockwise rotation.
•
Insert the water bottle ( B-16 ) into the water
bottle cage.