English
Operating instructions
13
Z15.027
V01
For a deep cleaning, we suggest to disassemble the pump’s lid operating as follows:
•
unscrew the non-return valve’s knob [24] from the pump [3] and extract the sphere [25] making sure not to lose it;
•
unscrew completely the knobs [27] and separate the pump’s lid [28] from the body [3];
•
carefully extract the pump’s paddles [29], making sure not to lose the springs [30]. When extracted, the springs
tend to push the paddles outside.
When reassembling, insert paddles in the pump with the groove looking downwards.
•
each part needs thorough washing with warm water and detergent, and rinsing with cold water. In particular, use
the tube-brushes to clean the inside of the faucet and that of the labyrinth [21]. Clean cream dispenser's [10]
holes with a suitable brush.
Note:
It is advisable to leave parts soaking in the detergent solution for a few hours (i.e. when the machine is
not been used) in order to dissolve all residues.
•
before reassembling parts lubricate gaskets with food-compatible grease.
4)
Sanitising
•
Prepare DISINFECTANT SOLUTION following the product instruction and pour in the container;
•
turn on dispensing for as long as necessary. If required, let solution work for longer, turn off machine (to avoid
using refrigerator needlessly);
•
if necessary, rinse machine by operating with fresh water (following disinfection, do not handle any parts which
will come into contact with food).
6.3
Accurate washing of the accessories
During the disassembly of the accessories for an accurate washing, check their O-
rings [G], following the directions reported in par. 7.1.
Steel cream injector
The steel cream injector [41] must be washed with hot water and detergent and disin-
fecting solution, making sure to remove any residual cream from the inside and from
the openings on the point, then rinsed with cold water.
Filling extension
