- 9 -
GB
In the event of the user or the installation technician failing to observe the instructions given in this manual, the Firm
disclaims all responsibility thereof and cannot be held liable for any accidents or trouble caused by such non-observance.
THE MANUFACTURER DISCLAIMS ALL RESPONSIBILITY FOR ANY INACCURACIES IN THIS BOOKLET THAT MAY BE
DUE TO TYPING OR PRINTING MISTAKES. THE MANUFACTURER, MOREOVER, RESERVES THE RIGHT TO MAKE THE
MODIFICATIONS TO THE PRODUCT IT CONSIDERS USEFUL OR NECESSARY, WITHOUT AFFECTING ITS BASIC FEATURES.
GENERAL NOTICES
-
Read the following instruction with care as it is essential for “safety” when operating, maintaining and using the
appliance.
-
This handbook should be always kept ready for consultation.
-
Remove all packaging from the appliance and make sure of its integrity.
-
Should you have any doubts so don’t use the appliance and ask an expert.
-
The packaging elements (plastic bag, polystyrene, nails) shouldn’t be left within children’s reach, since it might be
dangerous.
-
Before installation make sure that the indications on the data badge correspond to those of the distribution
network.
-
The plate is on the left side, at the bottom.
-
Installation must be carried out by an expert in compliance with the manufacturer’s instruction.
-
This appliance is to be intended for the only use it was first conceived.
-
Any other use is to be considered as unbecoming and therefore dangerous.
-
The appliance must be attended to only by a qualified person.
-
Before cleaning disconnect the appliance form the electric distribution network.
-
Disconnect the appliance in case of faulty performance or breakdown.
-
For repairing it contact an authorised service agency and ask for the original spare parts.
-
The non-observance of what mentioned above may compromise the appliance safety.
-
Electric safety is ensured only from an effective earth connection, according to the security regulations.
-
It is operative to verify this important requisite, if there a are any doubts ask for a test by qualified
people.
-
The manufacturer is not responsible for eventual damages caused from the missing earth connection.
-
The appliance must be included in an equipotential system, whose efficiency must be verified according to the in
force regulations.
-
After using disconnect the appliance.
-
Don’t clear the appliance with strong and direct water jets.
-
For installation an automatic circuit breaker, with opening distance from the contacts of 3 or more mm is required,
don’t obstruct the ventilation opening that allow heat removal.
-
To avoid the risk of oxidation or of chemical damages in general it is necessary to clean stainless steel surfaces
with care.
-
Should the appliance be installed against a wall, make sure that the wall is in heat resistant material, otherwise it
is suggested you should keep a 100 mm. Distance or you should interphone a sheet of isolating not inflammable
material.
-
All the appliances are complete with a cable, cm 200 long, with sufficient section for maximum load.
-
The flexible cable for electric supply must not have characteristics inferior to rubber insulation H07RN-T type.
