1 8
V. INSTALLATION
•
Carefully read the installation and maintenance
procedures given in this instruction manual before
installing appliance.
• Installation, maintenance and conversion to
another type of gas must only be carried out by
qualified personnel authorised by the
manufacturer.
•
Failure to observe the correct appliance installation,
conversion and modification procedures can cause
damage to the appliance, danger to persons and
invalidates the Manufacturer’s warranty.
1. REFERENCE STANDARDS
•
Install the appliance in accordance with the safety
regulations and local laws of the country where used.
2. UNPACKING
IMPORTANT!
Immediately check for any damage caused during
transport.
•
The forwarder is responsible for the goods during
transport and delivery.
•
Inspect the packing before and after unloading.
•
Make a complaint to the forwarder in case of visible or
hidden damage, reporting any damage or shortages on
the dispatch note on delivery.
•
The driver must sign the dispatch note: the forwarder can
reject the claim if the dispatch note is not signed (the
forwarder can provide the necessary form).
• Unpack, taking care not to damage the
equipment. Wear protective gloves.
•
Carefully remove the protective film from metal surfaces
and clean any traces of glue with a suitable solvent.
•
For hidden damage or shortages becoming apparent only
after unpacking, request the forwarder for inspection of
the goods within and not later than 15 days of delivery.
•
Keep all the documentation contained in the packing.
3. POSITIONING
•
Handle the equipment with care in order to avoid damage
or danger to persons. Use a pallet for handling and
positioning.
•
The installation diagram provided in this instruction
manual gives the appliance dimensions and the position
of connections (gas, electricity, water). Check that they
are available and ready for making all the necessary
connections.
•
The appliance can be installed separately or combined
with other appliances of the same range.
•
The appliances are not designed for built-in installation. Leave
at least 10 cm between the appliance and side or rear walls.
•
Suitably insulate surfaces that are at distances less than
those recommended.
•
Maintain an adequate distance between the appliance
and any combustible walls. Do not store or use flammable
materials and liquids near the appliance.
•
Leave an adequate space between the appliance and
any side walls in order to enable subsequent servicing
or maintenance operations.
•
Check and if necessary level the appliance after
positioning. Incorrect levelling can cause appliance
malfunctioning.
IV. THE ENVIRONMENT
1. PACKING
Packing materials are environment friendly and
can be stored without risk, or burned in a special
waste incineration plant.
Recyclable plastic components are marked with:
Polyethylene:
outer wrapping, instruction booklet
bag, gas nozzle bag.
Polypropylene:
roof packing panels, straps.
Polystyrene foam:
corner protectors.
2. USE
Our appliances offer high performance and efficiency. To
reduce consumption of electricity, water or gas, do not use
the appliance empty or in conditions that compromise
optimal efficiency (e.g. with doors or lids open, etc.); the
appliance is used in a well-ventilated place to avoid the
creation of dangerous mixtures of unburnt gases in the room.
Whenever possible, pre-heat only before use.
3. CLEANING
In order to reduce the emission of pollutants into the
environment, clean the appliance (externally and when
necessary internally) with products that are more than 90%
biodegradable
(for fur ther information, see chap. V
“CLEANING”).
4. DISPOSAL
Do not disperse in the environment. Our
appliances are manufactured using more
than 90% (in weight) recyclable metals
(stainless steel, iron, aluminium, galvanised
sheet, copper, etc.).
Make the appliance unusable by removing
the power cable and any compartment or cavity closing
mechanisms (when present) in order to avoid the risk of
someone becoming closed inside.
PE
PP
PS
