7
BASIC CUTTING AND BENDING INSTRUCTIONS
Important:
Always read, understand and obey the safety instructions included with
your new DBC-16H Combination Rebar Cutter and Bender before operating this tool or
any other power tool.
PRE-SUE CHECKS
1.
WARNING:
Do not expose the tool to rain or wet conditions. Water entering a
power tools will increase the risk of electric shock.
2.
WARNING:
Wear safety goggles, safety glasses with side shields or a face shield
when using these tools.
3.
Check that the power source is appropriate to the tool.
CARE:
If voltage is too high, the motor will burn out. If voltage is too low,
insufficient power will be generated. Never use DC current.
4.
WARNING:
Avoid accidental starting. Ensure the switch is in the off-position before
plugging in.
5.
Check that cord is undamaged and that plug is not loose.
CAUTION:
Cut or abraded covering could result in a short and electric shock to
operator.
6.
Check and keep work area clean and enough work space.
7.
Check condition of cutter blocks and tightness of cutter block bolts. - CHECK FOR
CRACKS OR DAMAGE, LOOSEN BOLTS
8.
Before using, always check that the two bolts on each cutter block are properly
tightened. Using a loose block will result in damage to block and housing. Also
check condition of cutter blocks. If either cutting edge is dull or chipped, remove
retaining bolts and rotate both blocks so that two new edges come into use. Replace
and tighten bolts. (Each block has four cutting edges.) When all four cutting edges
have been used or if either block is cracked or otherwise damaged, replace both
blocks.
CAUTION: A loose or cracked block may result in injury to operator.
