_ Electric Cookers _ rev. 1 _____________________________ CV5P – CV5P5 – CV5E-90 A – CM5E-90 A –
CV2R _
________________________________________________________________________________________
page 5 _
AIR INPUT
MIN. SECTION 100 cm
2
MIN. SECTION 100 cm
2
MIN. SECTION 100 cm
2
Fig. a
Fig. b
Fig. c
Residual risks
-
Keep away from the appliance unskilled personel.
-
With hot oven, open the door carefully in order to avoid violent hot fumes exit, that my
cause burning.
-
The appliance contains electrical parts and must never be washed with a jet of water or
steam.
-
To avoid wrong installation, the right gas connection is showed on a label that identifies
the correct gas type to use.
-
The appliance is electrically connected: before attempting any cleaning operation, cut
power to the appliance.
-
Do not use the door handle to move the appliance (the glass panel may break).
-
The removable parts of the cooking top, after the cleaning operation, must be placed
correctly in their housing in order to avoid anomalous and dangerous functioning of the
burners.
4. Gas connection
Connect the appliance to a gas cylinder or mains gas pipe according to the prescriptions
of standards (as per current national installation norms and subsequent amendments). To
connect gas, use an approved rigid metal pipe in copper or stainless-steel (the current
national installation norms and subsequent amendments). The appliance is equipped with
threaded GJ
½
” pipes for gas inflow. Check if the appliance is designed to operate on the
same type of gas as supplied and if pressure is set for that type of gas. Otherwise, carry out
the operations indicated in paragraph “ADAPTING TO DIFFERENT TYPES OF GAS”.
IMPORTANT
-
Make sure that supply pressure matches the values indicated in the table
“Burner and nozzle characteristics” (tab.1-2).
If supply pressures do not match the values in the table, eliminate the cause of this, or
inform the gas company and do not use the appliance. Connection with rigid or flexible metal
pipes must not cause stresses to the appliance pipe (“train”).
5. Electric connection
Before performing the electric connection
, make sure that:
-
the relief valve and the system can stand the appliance load (see data on the rating
plate);
-
THE SUPPLY SYSTEM IS EQUIPPED WITH AN APPROPRIATE GROUND
CONNECTION IN ACCORDANCE WITH THE REGULATIONS IN FORCE;
-
the omnipolar system used for the connection can be easily reached with the
appliance installed.
