33
d-r
DOOR OPEN
Deactivati
on of the
exits. The
cycle is not
blocked
and
restarts
when the
door is
closed.
Close the door
ALL
GAS CHAMBER
Block of
the cycle
in
progress.
Check the gas
system
Alt
THERMAL
ALARM
Block of
the cycle
in
progress.
Press the red
button on the
safety
thermostat
body.
ErL
ELECTRONIC
BOARD
CONNECTION
Washing
interruptio
n
Check
electronic
board
OVEN
THE OVEN DOES NOT START
-
Check that the multiple pole switch is closed and
there is mains voltage.
-
Check that the gas shut-off cock upstream of the
appliance is open.
- Check integrity of the oven protection fuses.
- Ensure the oven door is correctly closed.
-
Check to have correctly set the cooking cycle
parameters.
- Ascertain the oven is not in error.
THE FAN STOPS DURING FUNCTIONING.
-
Switch-off the oven and wait for the motor thermal
protection to automatically reset.
- Ensure that the cooling inlets are not obstructed.
WATER DOES NOT FLOW INTO THE HUMIDIFIER
TUBES.
- Check that the water shut-off cock is open.
THE IMPELLER DOES NOT ROTATE.
Check the water pressure, it must be higher than
150 kPa.
20.
REPLACING COMPONENTS
REMINDERS FOR REPLACING COMPONENTS
SHUT THE GAS SHUT-OFF VALVE
AND/OR SWITCH THE APPLIANCE OFF
AT THE MAIN SWITCH INSTALLED
UPSTREAM.
AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS
AT CONNECTION POINTS.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE CARRYING
OUT ANY OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
OVEN
SOSTITUTION OF THE LAMP
- Open the oven door.
- Remove the protection
- Remove and replace the component.
-
Reassemble all parts. For assembly, proceed in
reverse order.
SOSTITUTION OF THE ELECTRICAL COMPONENTS
- Remove the left panel.
- Remove the control panel
- Remove and replace the component.
-
Reassemble all parts. For assembly, proceed in
reverse order.
GAS OVEN
REPLACING THE GAS VALVE AND BURNER CONTROL
CARD.
- Remove the left panel.
- Remove and replace the component.
