POWER MAX II INSTRUCTION MANUAL
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
the Easy Glide
™
work surface.
3) Secure the bit to the shaft by turning the set screw
clockwise with the hex wrench (Fig. 2).
IMPORTANT: Always secure the bit to the flat side of the
motor shaft. Tightening the bit to the rounded side can scar
the shaft and prevent bit removal!
B. Sponge Installation
The technologically advanced Super Sponge™ can absorb over
10 times its weight in water. Its superior wicking ability insures a
sufficient water supply to protect the bit and keep the glass cool.
1) Wet the Super Sponge
™
by immersing it in water until soft
and pliable.
2) Fill the water reservoir (Fig.3) about 3/4 of the way to the
top. You may add special grinding lubricant if desired.
3) Insert the sponge between the sponge holder on the work
surface and grinder bit so that the bottom of the sponge is in
contact with the coolant/water in the reservoir and the top of
the sponge is in contact with the diamond surface of the bit
(sponge may be trimmed to ensure proper fit).
4) The wet sponge should remain in contact with the bit
while grinding (Fig.4). Periodically rinse out the sponge to
remove grinding residue. When the sponge becomes worn,
replace it.
5) Should your sponge become dry during periods of nonuse,
simply immerse in water & reinstall.
6) The Power Max II comes with two work surface adaptors
designed to allow the use of a 1” and 3/4” bit (Fig.5). After
the surface grid has been installed, place the grid surface
adaptor into the grid (Fig.6). Be sure to use the adaptor that
matches the bit you are using.
7) Soak the sponge in water, then position it into the grid
surface adaptor located behind the water reservoir.
Deluxe Models Only
1) Use the Universal Face Shield
™
by simply removing the
paper covering from the shield (Fig.7), put it on the frame,
then slide the base of the frame underneath the grinder body
(Fig.8). 2) Deluxe models also come with an Easy-On
™
Footswitch. This switch allows you to easily turn the grinder
on or off with a simple tap of the toe. To use, plug grinder
directly into the footswitch, then plug footswitch into any
outlet. Turn grinder to the ON position.
3) The Step-Up Work
™
Surface has pins on its bottom that
fit into the grid cover for easy installation (Fig.9).
3) The 1/4” grinder bit is useful for both drilling holes and
intricate grinding. To setup the 1/4” bit, simply install work
surface, then place the 1/4” bit directly into the top of the
shaft making sure the hex screw lines up with the flat side
PAGE 3 -
Fig.6
Fig.7
