Diamond Products CPG80E, Operator'S Manual

Page: 13 / 28

OPERATING
Installing the Grinding Head
WARNING
•
DO NOT install a grinding
head with the motor running.
Failure to properly secure the grinding
head may cause parts to loosen or fall
off the saw.
CAUTION
•
Wear gloves and be alert to the
surrounding environment when
handling grinding heads.
1. Pull back on the handlebar and lay the floor
grinder on the ground into the grinding
head assembly position.
Grinding Head Assembly Position
Disk Mounting Flange
2. With the disk mounting flange exposed,
place the grinding head onto the flange and
align the four bolt holes.
3. Attach the grinding head to the flange by
installing four 3/8”-16 flat head cap screws
through the grinding head into the disk
mounting flange and tighten to secure.
Grinding Head Bolts
4. Pull the floor grinder back up into the
normal operating position.
Removing the Grinding Head
CAUTION
• DO NOT remove a grinding head with
the motor running.
1. Pull back on the handlebar and lay the floor
grinder on the ground into the grinding
head assembly position.
Grinding Head Assembly Position
2. Remove the four 3/8-16” flat heat cap
screws attaching the grinding head to the
disk mounting flange
3. Pull the floor grinder back up into the
normal operating position.
13