Diamond Products CPG80E, Operator'S Manual

Page: 16 / 28

OPERATING
7. With both hands firmly on the handlebar,
move the grinder from side to side ensuring
not to stop in one spot too long as this will
lead to grooving of the surface.
8. Keep the rubber skirt on the front guard
assembly firmly on the surface to minimize
slurry spray.
9. When the grinding is complete, move the
starter switch to the OFF position.
10. Maintain contact between the grinding
head and the ground until the grinding
head comes to a full stop.
11. Shut the water control valve.
12. Disconnect the floor grinder from the power
source.
13. Turn off the water supply and disconnect
the supply hose to the grinder.
Edging
The CPG80E low profile floor grinder has the
capability of edge grinding close to walls. The
rear axle is designed to be adjusted to allow for
both left and right hand edge grinding.
Edge Grinding Adjustments
1. On the rear axle, remove the thumb screw
from the rear axle weldment.
2. Using a 9/16” wrench, loosen the two
adjustment bolts to allow for rotation of the
rear axle.
Rear Axle Adjustment
3. For right side edge grinding, rotate the
wheels to the left.
Right Side Edge Grinding
4. For left side edge grinding, rotate the
wheels to the right.
Left Side Edge Grinding
5. When the rear axle is properly aligned,
tighten the two adjustment bolts.
6. Reinstall the thumb screw and tighten to
secure the axle in place.
7. Operate the grinder in accordance with
either the dry or wet grinding instructions
called out in this manual.
16