Diamond Products CC5049D, Operator'S Manual

Page: 50 / 68

MAINTENANCE
Inner Safety Filter
4. Inspect the inside of the air cleaner housing
and the end cover for debris, and wipe
them down with a damp cloth as
necessary. DO NOT use compressed air to
blow out the inside of the air cleaner
housing. DO NOT allow dust to enter the
air intake tube when cleaning or replacing
parts.
5. Place the new inner safety filter into the air
cleaner housing until it is fully seated.
6. Place the new outer safety filter into the air
filter housing over the inner safety filter and
gently push the filter into the unit until it
feels secure.
7. Place the end cover tightly up against the
ridge at the end of the air cleaner housing.
8. Turn the end cover clockwise to lock the
cover onto the air cleaner housing, making
sure the dust ejector boot is in the vertical
position.
9. Push the tab in on the air cleaner housing
end cover to secure.
10. Press the restriction indicator reset button
on the restriction indicator after the unit has
been cleaned.
1000 Service Hours
Replace Radiator Coolant
Ensure the engine is turned OFF and cooled
down prior to replacing the radiator coolant.
1. Unbolt the three cap screws attaching the
front radiator shroud to the radiator and
remove the shroud.
2. Disconnect wire harness from the spotlight
if installed.
3. Place a drain pan under the radiator drain
valve.
4. Slowly remove the radiator cap.
CAUTION
Remove the radiator cap only when it feels
cool to the touch, and always open it slowly
to relieve any built up pressure.
5. Open the drain valve handle and drain the
fluid completely. Dispose of the used fluid
according to city, state, and federal
regulations.
6. Close the drain valve handle.
Radiator Drain Valve
7. Add a 50/50 mix of water and anti-freeze
through the fill port until the fluid reaches
the overflow hole inside the filler neck.
8. Replace the radiator cap and retighten to
secure.
9. Reinstall the radiator shroud.
10. Remove the coolant recovery tank cap.
Coolant Recovery Tank
50