MAINTENANCE
Daily Service
Check Engine Oil Level
Prior to checking the engine oil level, ensure
that there is no blade installed on the saw and
that the saw frame is in a level position.
1. Remove the engine oil dipstick from the oil
filter side of the engine. (Between the
engine and saw upright assembly)
Engine Oil Dipstick
2. Check the oil level on the dipstick. The
level should be between the two notches.
Engine Oil Level Indicators
3. If the level is low, remove the engine oil fill
cap located on the right, rear side of the
engine above the dipstick.
Engine Oil Fill Cap
4. Add oil until the level is correct on the
dipstick.
5. Replace the engine oil fill cap.
Check Fuel Level
Prior to checking the fuel level, ensure that
there is no blade installed on the saw and that
the saw frame is in a level position.
1. With the ignition switch in the ON position,
the Home screen will appear. The fuel level
gauge will be displayed on the right side of
the display.
2. If fuel level is low, remove the fuel tank fill
cap located on the left side of the upright
assembly.
Fuel Tank Fill Cap
3. Fill the fuel tank with ultra-low sulfur diesel
fuel only.
4. Replace the fuel tank fill cap.
Hydraulic System
WARNING
Always place a piece of
cardboard or paper up
against hydraulic
components, or use a leak detection fluid
to check for hydraulic fluid leaks. Keep
all body parts away from leaks and/or
areas that may eject hydraulic fluid.
Pressurized hydraulic fluid can penetrate
the skin, causing serious injuries. Seek
medical attention immediately!
Always make sure any hydraulic
components being serviced are not
supporting the weight of other saw
components. If a component is under
pressure when connections points are
loosened, oil may spray out forcefully.
42
Summary of Contents for CC5049D
