Diamond Power Products CC7074, Operator'S Manual

Page: 27 / 44

24
5. Remove all tools from the area and lower the saw
completely. The blade flanges must be at least 1/4”
from the ground to prevent component damage.
Note: Make sure both skid plates on the front of the
saw are in the correct set of holes in order to lower
the saw completely (refer to CC7074 Parts List)
.
6. Readjust the depth bolts as necessary.
Handlebar Cylinder Rod
The handlebar cylinder rod must be serviced by
Diamond Products if the handlebars can be moved up or
down in excess amounts when locked in place
(movement may feel sluggish). Send the entire assembly
to Diamond Products to be recharged or pressurized.
Removing the Cylinder Rod
1. Disconnect the two wires from the solenoid block
valve.
2. Remove the hairpin cotter and clevis pin from the
cylinder rod end.
Figure 20: Clevis Pin
3. Holding the cylinder, remove the hairpin cotter and
clevis pin from the isolator mount tube.
4. Remove the entire assembly from the saw.
Connecting the Cylinder Rod
1. Fit the cylinder into the cylinder rod end mount and
isolator mount tube.
2. Fit the clevis pin through the cylinder rod end mount
and cylinder rod end. Secure in place with the
hairpin cotter.
3. Fit the second clevis pin through the isolator mount
tube and cylinder u-block. Secure in place with the
hairpin cotter.
Figure 21: Clevis Pin
4. Connect the two wires to the solenoid block valve
according to the wiring diagrams in the CC7074
Parts List.
Battery
WARNING

Ignitable explosive gases are emitted
from the battery. DO NOT expose the
battery to sparks or open flames, and
keep the area around the battery
well-ventilated.

Disconnect the battery prior to servicing the
saw (unless stated otherwise).

Always keep the battery cable clamps
away from the battery terminals when
the battery is disconnected to avoid
accidental connections while servicing.

Always be sure to connect the battery cables
to the proper terminal when reconnecting.
CAUTION

Use a proper battery tester when testing the
battery strength.

Use protective eyewear or a face shield and
avoid contact with the skin when
handling/servicing the battery.
The saw contains a charged battery with one positive
cable lead and one negative cable lead.