5
August 2014
To turn your sensor on, press the button with the “DK” logo on the top of the
Sensor. The green indicator light on the top of the sensor will turn on.
To turn off, press the button. The green indicator light will turn off.
Pairing your Diamond Kinetics Sensor
You will need to pair the Diamond Kinetics Sensor to your iOS device to collect data.
● Go to Settings > Bluetooth
● Enable Bluetooth in the Settings Menu, if it is not already on.
● Select the "SwingTracker” sensor.
If you do not see SwingTracker in the device list
● Confirm that the sensor is charged. If it is not, see “Charging your Sensor”
● Check that it is not connected to another nearby iOS device.
● Confirm SwingTracker is close to the iOS device and try again.
Charging your Sensor
Turn off the Sensor. Hold the sensor upright and logo facing up. Rotate the top
grey section of the sensor counterclockwise to reveal the charging port on the
bottom of the sensor. You will feel the bottom of the sensor “unlock” as you
begin to rotate the bottom.
Insert the small end of the USB charging cable provided into the exposed
charging port on the sensor. The status indicator will begin to flash red. The
status indicator will emit a solid red light when charging is complete, taking
approximately 3 hours.
Remove the charging cable from the computer and sensor. Rotate the top grey
section of the sensor clockwise to cover the charging port. You will feel the
bottom green section of the sensor lock into place.
Never force a charge cable into a USB port of your Diamond Kinetics
sensor. If the charge contact does not easily fit into the USB port,
confirm that they are properly aligned before attempting to insert again.
ONLY use the USB charging cable provided to charge your Diamond
Kinetics sensor. Diamond Kinetics is not responsible for the operation of
third-party accessories.
Initial Calibration of your Sensor
Summary of Contents for DKST01
Page 1: ...1 August 2014 User Guide...
