Diamond H2O
N1022 Quality Drive / PO Box 170 / Greenville, WI 54942
Ph: (920) 757-5440 / (866) 757-9287 / Fax: (920) 757-5819
5.
CONTROL VALVE INSTRUCTIONS continued
5.4.
OEM GENERAL INSTRUCTIONS
The control valve offers multiple procedures that allow the valve to be modified to suit the needs of
the installation. These procedures are:
• OEM System Setup
• Installer Displays & Settings (either 1
-99 Days between Regeneration option or 7-Day option)
• User Displays
These procedures can be accessed in any order. Details on each of the procedures are provided
below and on the following pages.
When in operation, normal user displays show the time of day or days remaining before
regeneration. When stepping through a procedure, if no buttons are pressed within five minutes
the display returns to a normal user display. Any changes made prior to the five minute time out
are incorporated.
To quickly exit Installer Displays & Settings or OEM Setup, simultaneously press SET
and
▼
. Any
changes made prior to the exit are incorporated.
To reinitialize the control valve, check to make sure the valve is in the User Display. Then
simultaneously press SET and
▼
or unplug power source plug (4-pin connector) on the circuit
board, wait 3 seconds and plug back in.
5.5.
OEM SYSTEM SETUP
STEP 1SS:
From normal mode, press the SET and
▲
buttons
simultaneously for 3 seconds and release. Then
press the SET and
▲
buttons simultaneously for 3
seconds and release.
STEP 2SS:
Choose the desired program by pressing the
▲
or
▼
buttons. Prior to selecting a program, verify the
correct valve body, main piston, regenerant piston,
and stack are being used, and that the injector or
injector plug(s) are in the correct locations. See
Valve Body Compliance Table in the WS1 and WS1.25
Drawings and Service Manual. Press SET button to
go to Step 3SS.
Page 8
