I
0
1
12. USING THE VACUUM CLEANER
I - 3
Motors switch ON
O -
Switch OFF
13. FILTER REPLACEMENT
14. TROUBLESHOOTING
You can thus solve any problem that may occur.
Motors do not start.
u
No electrical voltage.
u
Check cables, plugs and socket.
Suction capacity decreases slowly.
u
Filter, nozzle, suction hose or suction pipe may be blocked.
u
Check, clean accessories. Clean filter.
Dust comes out during the vacuuming.
u
Filter has not been fastened correctly or is defective.
u
Check to see if filter is sitting properly; replace if required.
1 - Close the bag with two
distanced bands.
2 - Cut the strip between the
two bands.
3 - Pull the Infinity Bag end to
make a new bag.
15. COLLECTION BAG USE
The dust and the particles are collected in a bag placed in the container
under the hopper.
The Infinity Bag system consists in a plastic tubular from which are ob
-
tained 20/30 bags of different weights and dimensions.
Once finished or damaged, the tubular must be replaced by a new refill.
The operations below described must be carried out when machine is
turned off.
Before switching ON the vacuum be sure the
container is empty
1
3
2
2
Push for forced filters
cleaning
3
Socket
1. Disconnect and lift the head.
2. Remove the filter’s cylindrical
steel protection
(unscrewing the screws on the
edge)
3. Unscrew the wing nut and
remove the spring and washer
4. Replace the filter with a proper
one for the vacuum cleaner
in use
5. Install the new filter according to
the label on the bottom of the filter
• Washer with rubber part facing
the base of the
filter
• Spring
• Plastic wing nut
6. Mount the cylindrical protection,
then reconnect the head on the
filtering chamber
