Installing the Dialogic® Vision™ Server TIGI2U
12
Compliance statements
EU R&TTE statement
This product is intended to be connected to the following public telecommunication networks:
•
2048 kbit/s 120 ohm digital structured or unstructured ONP leased line in all EU countries.
•
Euro-ISDN Primary Rate Access in all EU countries (for servers with up to two line card interfaces and
no signaling interface).
For more information, refer to http://www.dialogic.com/declarations/default.htm.
FCC Part 15 Class A statement
This board has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference, in which case the user will be required to
correct the interference at his or her own expense. Modifications not expressly approved by Dialogic may
void the FCC granted authority to operate the equipment.
FCC Part 68 statement
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the
bottom of this equipment is a label that contains, among other information, a product identifier in the
format US:EMCXDNANXXXXXXXX. If requested, this number must be provided to the telephone company.
The telephone company will need to know the Service Order Code, the Facility Interface Code, and the
wiring configuration (or USOC jack type) corresponding to the service you are ordering, as shown in the
following table:
Service type
Facility
interface code
Service
order code
USOC
jack type
4-wire 1.544 Mbps (DS1) with super frame (SF),
alternate mark inversion (AMI), no line power, 100
ohms.
04DU9.BN
6.0N
RJ-48C
4-wire 1.544 Mbps (DS1) with SF, bipolar with
eight-zero substitution (B8ZS), no line power, 100
ohms.
04DU9.DN
6.0N
RJ-48C
4-wire 1.544 Mbps (DS1) with extended super
frame (ESF), AMI, no line power, 100 ohms.
04DU9.1KN
6.0N
RJ-48C
4-wire 1.544 Mbps (DS1) with ESF, bipolar with
eight-zero substitution (B8ZS), no line power, 100
ohms.
04DU9.1SN
6.0N
RJ-48C
If the equipment causes harm to the telephone network, the telephone company will notify you in advance
that temporary discontinuance of service may be required. If advance notice is not practical, the telephone
company will notify you as soon as possible. Also, you will be advised of your right to file a complaint with
the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or procedures that
could affect the operation of the equipment. If this happens the telephone company will provide advance
notice so that you can make necessary modifications to maintain uninterrupted service.
This product is not intended for customer repair.
If you experience trouble with this equipment, contact Dialogic for warranty and repair information. The
telephone company may ask that you disconnect this equipment from the network until the problem has
been corrected or until you are sure that the equipment is not malfunctioning. This board may not be
connected to party lines or used on coin service lines provided by the telephone company. The part 68
affidavit for digital and subrate services is included separately.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
