Installing the Dialogic
®
Vision™ AQR1U Server
15
The following illustration shows the slide rail assembly:
Four-Post Rack with Square Holes
If the four-post rack at your site has square holes, refer to the instructions included in the
box with the Tool-Less Blade Slide Kit.
Four-Post Rack with Round Holes
If the four-post rack at your site has round holes, complete the following procedure to use
the post adapter and screw kit to convert the square holes to round holes:
1.
Refer to the instructions included in the box with the Tool-Less Blade Slide Kit to
remove the inner channels from the slide kit and attach them to each side of the server.
2.
Set the instructions that were included with the slide kit aside. You will not need these
for the rest of the slide kit installation.
3.
Install the hex standoff screws at each end of the slide using a 3/8" hex wrench. Torque
to 3.5 kgf-cm (3 lbf-in). You will install these screws a total of 4 times.
4.
Install the 4 adapter brackets at each end of the slide over the hex screws you installed
in Step 3.
