14
Installing the Rack Mount Kit
When mounting the server, follow these guidelines:
Elevated operating ambient:
If installed in a closed or multi-unit rack assembly,
the operating ambient temperature of the rack environment may be greater than
room ambient. Therefore, consideration should be given to installing the equipment
in an environment compatible with the maximum ambient temperature (Tma)
specified by the manufacturer.
Reduced air flow:
Installation of the equipment in a rack should be such that the
amount of air flow required for safe operation of the equipment is not compromised.
Mechanical loading:
Mounting of the equipment in the rack should be such that a
hazardous condition is not achieved due to uneven mechanical loading.
Circuit overloading:
Consideration should be given to the connection of the
equipment to the supply circuit and the effect that overloading of the circuits might
have on overcurrent protection and supply wiring. Appropriate consideration of
equipment nameplate ratings should be used when addressing this concern.
Reliable earthing:
Reliable earthing of rack-mounted equipment should be
maintained. Particular attention should be given to supply connections other than
direct connections to the branch circuit (for example, use of power strips).
Before you install the server, you must install a rack mount kit to support the server in the
rack.
The Vision AQR1U Server comes with a tool-less rail mount system and a conversion kit so
that the tool-less system can be used in a rack with either square holes or M5 round holes.
The round hole conversion kit uses M5 screws for mounting the adapter to the rack.
The rack mount kit is only used with a four-post rack and cannot be used with a two-post
rack. Both kits may contain extra hardware.
Kit
Contents
Tool-less rail kit
Two slide rail assemblies
Ten M4 x 6 screws
Two M6 x 12 screws
Round hole conversion
kit
Two slide rail assemblies
Ten M4 x 6 screws (from the tool-less rail kit)
Four hex standoff screws (from the tool-less rail kit)
Four post adapter brackets
With M5 x 8 screws
Four 6-32 x 0.5" screws
Two ear washers
