IMG 1010 Quick Start Guide
GCEMS software installation.
To take advantage of all new features, it is recommended that the latest version of
GCEMS software be installed on the GCEMS Server. The most current software can be
obtained from the Dialogic Technical Support website.
1.
Go to the Dialogic Support Technical Website at
http://www.dialogic.com/support
2.
Select ‘Downloads’. You will require a logon username and password to access the
downloads site. (A support contract is needed to access this site.) Within this site will
be two software binary files with the following format. Download the latest version of
these files.
•
IMG_10.5.x.135.bin
•
IMGUserInterface_10.5.x.135.bin
NOTE: If you do not have a support contract with Dialogic, then the software supplied to
you on the Software CD can be used.
3.
Refer to the topics under the following headings in the Online Documentation to install
the GCEMS software
•
IMG 1010-Installation and Setup Guide > IMG 1010-Software Installation and Setup
Connecting DATA0 Port
1.
The port DATA 0 that is located on the rear of the IMG 1010 is a Gigabit-Ethernet port
and is dedicated to VoIP Bearer traffic. The DATA 0 port can be on either the same IP
network as the management network, or can be connected to a separate network. See
the topics under the following headings in the Online Documentation for more
information.
•
IMG 1010-Installation and Setup Guide > IMG 1010-Hardware Installation
2.
The IP addresses for these ports will be assigned through the ClientView GUI. See the
ClientView section below for more information.
Dialogic Corporation
Part # 07-8728-04
Page 8 of 9
