49
Dialogic
®
DSI SS7MD Programmer’s Manual Issue 3
6.2
General Configuration Messages
General configuration messages are typically issued by the
s7_mgt
protocol configuration utility, in which case
they need not, and should not, be generated by any user application software.
If the user elects not to use the
s7_mgt
protocol configuration utility, it is necessary for the application to
build and send messages that:
•
configure the
ssd
module
•
reset each board
•
configure each board
•
optionally configure additional routes
The messages in the general configuration category include:
•
SSD_MSG_RESET
-
SSD Reset Request
•
SSD_MSG_RST_BOARD
-
Board Reset Request
•
SSD_MSG_BOARD_INFO
-
Board Information Request
•
MGT_MSG_CONFIG0
-
Board Configuration Request
•
MGT_MSG_L1_CONFIG
-
Layer 1 Configuration Request
•
MGT_MSG_L1_END
-
Layer 1 Configuration End
•
MGT_MSG_NTP_CONFIG
-
Network Time Configuration
6.2.1
SSD_MSG_RESET – SSD Reset Request
Synopsis
Sets up ssd module run-time options at initialization time.
Note:
When using the s7_mgt protocol configuration utility, this message is generated by s7_mgt and
should not be generated by the user.
Format
Description
This message is used during initialization by the application to reset the ssd module and set up its run-time
parameters.
The confirmation message (if requested) indicates success with a
status
value of 0.
MESSAGE HEADER
Field Name
Meaning
type
SSD_MSG_RESET (0x7680)
id
0
src
Sending module ID
dst
SSD_module_ID
rsp_req
Used to request a confirmation.
hclass
0
status
0
err_info
0
len
24
PARAMETER AREA
Offset
Size
Name
0
1
Reserved. Set to 0.
1
2
Reserved. Set to 0.
3
1
mgmt_id
4
18
Reserved. Set to 0.
22
2
num_boards
